Your cart is empty.
Your cart is empty.Mounts inside your enclosure. Uses same keeper as above. Three different pull up forces. Installs either right side or left side by inverting. Use #4 screws or .125 rivets to install. Grabber catch has microswitch option to be used as a mechanical grabber catch with an electric switch. Switch is designed to operate an indicator light or form part of a non-safety related logic circuit.
Rafael
Reviewed in the United States on September 25, 2024
Top
The Stache
Reviewed in the United States on August 16, 2024
This was the identical latch for our Leisure Travel Van RV. It is an exact match. I was easily able to replace the broken latch. Note: no screws are included which is why I down-rated it. I used the original screws, but I would have needed to go out and find some if original screws had been stripped.
brut
Reviewed in the United States on June 10, 2024
They work great but the screw holes didn’t match the holes on my previous latches but that was easily overcome.
Cc
Reviewed in the United States on October 6, 2024
Great- took less than 10 minutes to install (replacement latch mechanism).
DS
Reviewed in the United States on June 18, 2023
Received what I expected and arrived much earlier than indicated.
Jim Burns
Reviewed in the United States on December 22, 2023
Was exactly like the one being replaced. Good quality, Good Price. Quick delivery. Very easy install
Customer
Reviewed in the United States on September 20, 2022
I've used these in my RVs for years. They work great and are easy to install. I just wish they would stamp the pull force somewhere on the body.
Paul R. Haller
Reviewed in the United States on February 5, 2018
I replaced a factory installed Norcold refridgerator in my 5th wheel trailer with a Samsung RF18 residential stainless front refer. I needed to keep the doors shut on the new refer while on the road without drilling into the new refer box. I attached the hook latches on these catches to the face of a 1 inch x 1/4 inch alumininum plate by drilling and tapping the plate and then adhering the plate to the new refer with super strong 3M double sided tape used on automobiles to adhere trim between the upper and lower doors right to the refer box The catch mechanisms are screwed to the bottom of the top doors and the top of the freezer door. These work great to keep the doors shut and are unseen keeping the sleek and modern refer sight lines intact. It took some time but what a great addition to my trailer and I don’t need to remember putting some Goldberg scheme Velcro wrapped gizmo around the door handles to keep them closed
Recommended Products
$25.00
$ 11 .99 $11.99