Your cart is empty.
Your cart is empty.Product Description
1. The heating tube of the cutting pen can only be bent once, not repeatedly at one point. Bending repeatedly at one point may cause breakage
2. Because of its special structure, the cutting pen can only cut medium and low density foam, and cannot cut materials other than foam. It is not suitable for or batch cutting.
3. Continuous cutting does not exceed half an hour, the power supply of the cutting pen has a switch, and the power supply can be prolonged after cutting off
4. We will test the power again before shipment, so the pen will have slight foam marks, please rest assured to buy
5. If you need to work for a long time, please choose a desktop cutting machine
Note:
1. Do not touch any hot surfaces. The tips will become very hot during operation.
2. The continuous operation shall not exceed 0.5 hours, and the cumulative time shall not exceed 2 to 3 hours
Specification:
Model: AIK-50
Material: -chrome alloy
Weight: 245g/8.6oz
Power: 24W
Normal temperature resistance: 20
Maximum temperature resistance: 1500℃
Pen Point Length: 20cm/7.9inch
Voltage: 110-250V
Plug Type: US Plug, EU Plug, UK Plug(Optional)
Product Usage Information:
There are some errors in the length of the pen tip due to different factory batches
Work continuously for no more than 0.5 hours, accumulatively no more than 2-3 hours
Pen power supplies of different lengths cannot be mixed. Each heating pen has its own independent power. Mixed use is either not hot or will burn.
Tina
Reviewed in the United States on March 10, 2025
This worked great. No mess. Easy to use and care for. When hot we placed on a cardboard egg carton and used the side of the carton to clean the tool before the next cut. Foam does smell be sure to have good ventilation. Good heat level and durable.
Richard Jr.
Reviewed in the United States on January 18, 2025
Cuts good and works as advertised
Nicole
Reviewed in the United States on August 19, 2024
Intended to use for cutting foam for some chair cushions. Was not super dense foam - and this tool did not work as intended. Would sink into the edge then couldn’t make a clean cut. They ended up being very jagged and not clean sharp edges.
Billy Frady
Reviewed in the United States on May 18, 2024
This makes it easy to cut foam board nice and straight. A lot better then using a knife or razor knife. Wish I would have bought sooner. You have to go slowly, and give it a rest , only use 30mins at a time then cool down. I have cut about 5 sheets cutting each sheet 2 to 3 times .so I cant say how long it will last. But so far so good.
Desi17683
Reviewed in the United States on November 23, 2024
I could not get this to cut through the foam cushion I was trying to cut in half. I ended up using a bread knife and it was much easier. Don’t waste your time with this unless you’re doing a very thin piece of foam. The foam cushion I tried to cut through was about 5 inches thick to give you perspective.
Jonathan Lau
Reviewed in the United States on November 13, 2024
Unfortunately, this is not for me. Although, I understand safety requirements, the hot wire is just not hot enough to cut the foam.
Terry
Reviewed in the United States on October 30, 2024
I used this cutter pen to slice-up some large polystyrene block packaging for recycling. Parts of the block were approximately 4" thick and the pen cut through them easily and at a reasonable speed. The product is not particularly sturdy but certainly up to the task I used it on so would be perfectly fine for hobby work. It does produce fumes when cutting so use in well-ventilated space - I worked in my garage with the door fully open.
J. Niedermier
Reviewed in the United States on October 25, 2024
Used it to cut foam for a Pelican style storage box, worked well.
Recommended Products